Sanyo HF10000L owner manual Lens Installation, Attaching the Strap

Turn the lens mount cover counter-clockwise. (See Fig. 1)

Remove the screw. (See Fig. 1)

Thread one end of the strap through the loop hole on the lens mount cover. (See Fig. 2)

Installation

Lens Installation

Before setting up the projector, install Projection Lens on the projector.

Before installation, check where the projector is used and prepare a suitable lens. For the specifications of Projection Lens, contact sales dealer where you purchased the projector.

- Do not use the optional lens below for this projector. Otherwise damages may result. LENS MODEL NO. : LNS-T01, LNS-T01Z

- Lens installation and replacement should be performed by the qualified service personnel.

-When setting the projector after lens installation, be sure to replace a Lens Cap to protect a surface.

-When carrying or holding up the projector, be careful not to put your hands on lens part. It may damage lens, cabinet, or mechanical parts.

Attaching the Strap

Connect the lens mount cover and the projector with the strap (supplied) to prevent the lens mount cover from falling down.

1

2

3

4 Fix the other end of the strap to the projector with the removed screw. (See Fig. 3)

Label

Matchmark (dot) on the cabinet

Matchmark (dot) on the lens mount cover

Lens Mount Cover Screw

Fig. 1

	Strap
	Lens Mount Cover
	Screw	Strap
		Loop Hole
	Fig. 3	Fig. 2
	✔Note:
	• The screw which is packed with the strap is not for use
	with this projector.
5	Fit the lens mount cover, align the matchmark on the lens mount
	cover with the left edge of the label on the cabinet, and then turn

the lens mount cover clockwise until it clicks. (See Fig.3)

17