Sanyo HF10000L owner manual Status Read Commands

Appendix

Status Read Commands

Format

The command is sent from PC to the projector with the format below;

“CR” [Command] [CR]

Command: one character (refer to the command table below.)

The projector decodes the command and returns the 'Character string' with the format below;

Command	Function	Return	Projector status
		value
		00	Power On
		80	Stand-by mode
		40	Countdown
		20	Cooling down
		10	Power Malfunction
		28	Cooling down at the temperature anomaly
		24	Cooling down at Power Management mode
CR0	Status Read	04	Power Management mode after Cooling down
		21	Cooling down after the projector is turned off when the lamps
			are out.
		81	Stand-by mode after Cooling down when the lamps are out.
		88	Stand-by mode after Cooling down at the temperature
			anomaly.
		2C	Cooling down when the projector is turned off by the shutter
			management function.
		8C	Stand-by mode after Cooling down by the shutter
			management function.
			%1 = Temperature at Sensor 1 (˚C)
			%2 = Temperature at Sensor 2 (˚C)
			(ex.) %1 = 12.3 (˚C), %2 = 23.4 (˚C)
CR6	Temperature Read	%1 %2	--> The projector returns “ 12.3 23.4”.
			(For each sensor, two digit and the tenth place numbers are
			displayed with a space between each temperature.)

?

Communication failure

The tables on page 97 and 98 show the typical command lists for controlling the projector. Please consult your local dealer for further information of other commands.

98