Computer Input
Auto PC Adjustment
Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Position H and Position V
to conform to your computer.
Direct Operation
The Auto PC adjustment function can be operated directly by pressing the AUTO PC button on the remote control.
Remote Control
AUTO PC button
| Menu Operation |
Auto PC adj. | |
1 | Press the MENU button to display the |
| Menu. Use the Point ed buttons to select PC adjust |
and then press the Point 8 or the SELECT button.
2 | Use the Point ed buttons to select Auto PC adj. and |
| then press the SELECT button. |
To store the adjusted parameters.
The adjusted parameters from the Auto PC Adjustment can be stored in the projector. Once the parameters are stored, the setting can be done just by selecting Mode in PC System Menu (p.35). See “Manual PC Adjustment” on pages 37, 38.
✔Note:
•Fine sync, Total dots, Position H and Position V of certain computers cannot be fully adjusted with the Auto PC Adjustment function. When the image is not provided properly with this operation, manual adjustments are required. (pp.37, 38)
•The Auto PC adjustment cannot be operated when 480i, 575i, 480p, 575p, 720p, 1035i, 1080i or 1080p is selected in the PC System Menu (p.35), or when the signal is coming from the
•Depending on the condition of signals and the type and length of cables, the signals may not be properly viewed.
Use the Point ed buttons to select “Auto PC adj.” and press the SELECT button.
Please wait... appears while the Auto PC adjustment is in process.
36