8.4Other Precautions
8.4.1Do not loosen the screws or disassemble the drive.
8.4.2Do not remove the PCB from the drive or swap the PCB with other drives.
8.4.3Do not solder the wire or other parts on the PCB, or reconstruct the PCB.
8.4.4Do not remove the sealing tape or label on the HDA.
8.4.5Turn off the power before removing or installing the DC power cable and SCSI interface cable. Turn off the power before removing or installing the
jumper.
8.4.6Remove the DC power and SCSI interface connectors carefully in order not to damage the contact pins and the connector housing.
8.4.7Do not move the drive when the disks are rotating or while the power is on or for 20 seconds after the power has been turned off.
9Maintenance
9.1The HDD itself is maintenance free and there are no individual parts that require maintenance. If maintenance for the HDD is required, the entire product will need to be serviced, since it can not be divided into parts. System maintenance should be executed by the host system.
9.2The supplier will repair or exchange the product due to malfunction covered under the warranty. The warranty and service will be agreed upon between the customer and the supplier. The supplier is neither liable or obligated to service any product due to carelessness or mishandling of product.
9.3Even if the drive fault occurs during the
Drawing No. Sheet No. Revision ６ | ||
K6610091 | 28/43 | 2005/2/23 |