Physical interface, Interface connectors

10Physical interface

10.1Connector Specifications

Use the mating connectors which are electrically and mechanically compatible. The following part numbers indicate the mating connectors.

Table 10.1 Interface connectors

Interface	Name	Part number	Manufacturer
WIDE LVD	SCSI interface connector	786090-7	AMP
		DHJ-PAC68-2AN	DDK
	DC power connector	Pin:61314-4	AMP
		Housing:1-480424-0	AMP
SCA-2 LVD	SCSI interface connector	787311-1	AMP
	with DC power connector	787565-1	AMP
		HD2-PA080-S11	DDK

10.2Cable Specifications

(1)SCSI Interface Cable

Use interface cables that meet the ANSI SCSI guideline.

The total cable length must be within the maximum cable length in case multiple drives are daisy chained. Specifications of maximum cable length are shown in Table 10.2 and Table 10.3.

The length of a cable connected between SCSI devices must be a minimum of 12 cm. (The stub length of the drive: 4 cm)

If an external cable the stub length of which becomes long is connected

to the devices, the cable length between the devices must be a minimum of (external stub length + 4 cm) x 3.

If data are transferred by Ultra SCSI (Fast-20) mode, Ultra2 SCSI (Fast-40) mode, Ultra160 SCSI (Fast-80) mode or Ultra320 SCSI (Fast-160) mode, check that the interface reflection noise does not influence the motion of the drive in the actual user’s system.

Drawing No. Sheet No. Revision ６
K6610091	29/43	2005/2/23