Hitachi HUS103030FL3600 Jumper Socket setting, Jumper connector layout Wide LVD drive

12Jumper Socket setting

12.1Jumper connector layout WIDE LVD drive

Option Jumper Connector (C3)

Force Single-Ended bus mode (11)

Disable Auto Start (9)

ID0 (7)

ID1 (5)

ID2 (3)

ID3 (1)

1	23
2	24

Enable Delayed Start (13) Write Protect (15) Reserved (17)

Reserved (19)

LED(with 0ohm) (21)

Term. Power to SCSI Bus (23,24)

GND (2,4,6,8,10,12,14,16,18,20) 5V(with 150ohm) (22)

Auxiliary Connector (C4)

		Reserved (2)
		Reserved (4)
		Reserved (6)
		LED (8)
2	12	GND (10)
1	11	Write Protect (12)
ID0 (1)
	5V (11)
ID1 (3)
ID2	N.C. (9)
(5)
ID3 (7)

Figure 12.1 Jumper connector layout (WIDE LVD drive)

Note 1. Green or White jumper sockets are used for the customer’s selection. (They are shown with thick lines in figure 13.1)

2.Shaded jumper sockets are default setting at the factory.

3.Reserved pins (C3-17,19; C4-2,4,6) are used at the factory. Installing or removing jumper sockets on these reserved pins will void any warranties of the HDD.

Do not connect an assigned pin to another assigned pin.

4.Jumpers are installed at C3-2,4 & 6,8 & 10,12 & 14,16 & 18,20 as spares. Customer can remove and use them for another jumper settings.

Drawing No. Sheet No. Revision ６
K6610091	38/43	2005/2/23