Xen IPK Xen Mail CTI Installation Guide
SE C T I O N 13
INSTALLING
TELANOPHY FROM A
NETWORK
To install TeLANophy applications on individual workstations from a network, perform the following procedures.
Because you must have network rights to create directories, copy files, and grant directory rights to other workstations, the network administrator may need to perform the “To copy TeLANophy installation files to a network directory” procedure for you.
To copy TeLANophy installation files to a network directory
1Log on to the network.
2On a network drive accessible to all workstations, create an installation directory for the applications. For example, for ViewMail, type
md x:\viewapps\viewmail
and press Enter.
3Insert the voice messaging system’s disc in the
To install TeLANophy from a network
1Choose “Start,” and then “Run.”
2Refer to the table on page 81 for the TeLANophy application path. Type:
<your network TeLANophy application path>\setup
and choose “OK.”
For example, for ViewMail, type
x:\viewapps\viewmail\full\setup
Warning! ViewMail and ViewFax must be installed in the same directory (the default). If ViewMail is already installed, do not install ViewCall Plus in the same directory, or both programs may not work properly.
3 Perform one of the following actions:
•If you are installing ViewCall Plus, in the Welcome dialogue box, choose “Next.”
•If you are not installing ViewCall Plus, go to step 6.
4In the Information dialogue box, choose “OK.”
5In the Install Options dialogue box, select “Local installation.”
6Follow the
No. 8557 - Release 1.1 | 2004 |
Doc. | June |
Setting Up TeLANophy | Chapter 6 - 83 |