Kodak 3000DSV-E manual Defining two separate areas, Defining Page-by-Page Print Area

Defining two separate areas

Define the areas to print by specifying the vertical and horizontal areas as follows: 2 end points for vertical and 4 end points for horizontal.

5

6

1 2 3 4

NOTE: The points defining the vertical and horizontal area can be selected in any order. Blinking lights on the indication panels indicate an improper entry of the specified area.

Defining Page-by-Page Print Area

•Using the vertical and horizontal points on the Area Indication panels, define the print areas of the image on the screen.

5

6

1 2 A 3 4

NOTES:

•The horizontal indicator marked A does not light up and cannot be used for defining an area.

•Four different areas cannot be defined on a single page.

•If the Area keys start blinking when the Print key is pressed, it indicates that the print area defined is not available. Specify the area again.

•Paper must be 11 x 17” (A3) when defining two areas and 8 1/2 x 11” (A4) when defining Page-by-Page print areas.

•Paper can be of any size when defining one area.

•The print area, once defined, is stored in memory for each paper size and print position. Press the Area Clear key to clear the area setting.

A-61371 September 2004 3-13