Kodak DP2000 manual Starting the Projector

Setting up the Projector

Starting the Projector

Note: We recommend using a surge protector power strip.

1.Remove the lens cap.

2.Plug the power cord into the side of the projector, and then plug it into your electrical outlet.

The fans start to run and the lamp LED on top of the projector lights orange until the software has initialized. Then the LED lights green.

3.Turn on the lamp by pressing the button on the keypad. The KODAK startup screen appears.

4.If you connected the projector to a video player, turn on the video player.

•The video image should appear on the projection screen. If a

computer source is active, press the button on the

keypad (page 23) or the button on the remote to display your video image. You can select a default source to determine which source the projector examines first during

power-up for active video; see “Default Source” on page 31.

• Use the buttons to adjust the volume.

5.If you connected the projector to a computer, turn on the computer. Make sure the computer external video port is activated. See “Portable and Laptop Activation Chart” on page 49. Note: With some computers, the order in which you power up

the equipment is very important. Most computers should be turned on last, after all other peripherals have been turned on. Refer to your computer documentation to determine the correct order.

•The computer image should appear on the projection screen.

If a video source is active, press the button on the

keypad (page 23) or the button on the remote to display your computer’s image.

•If necessary, make adjustments to the image using the projector’s on-screen menus. To open the menus, press the

button on the keypad or remote, then select the Display or Image sub-menu. For more information about the menus, see “Using the On-Screen Menus” on page 25.

17