Kodak 4600 Replacing the AUTO-FOCUS Switch Assembly, Installing the AUTO-FOCUS Switch Assembly

Replacements and Installations

Replacing the AUTO-FOCUS SWITCH ASSEMBLY

AUTO FOCUS

MOTOR BRACKET

LOCKING

TAB

AUTO FOCUS	grey, red,
	and black
SWITCH LEVER
	wires
AUTO FOCUS SWITCH ASSEMBLY	A091_4028GCA
	A091_4028GA

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the replacement procedure for the LOWER HOUSING ASSEMBLY.

[3]Remove the FOCUS KNOB.

[4]Remove the short, gray wire from the AUTO-

FOCUS DEFEAT SWITCH.

Important

It is necessary to push the AUTO-FOCUS BRACKET backward and forward to allow access to the SCREWS on the LENS MOUNT ASSEMBLY.

[5]Remove the 3 SCREWS from the LENS MOUNT ASSEMBLY.

[6]Lift and remove the LENS MOUNT ASSEMBLY.

[7]Remove the gray, red, and black wires from the

AUTO FOCUS SWITCH ASSEMBLY.

Important

Keep the AUTO-FOCUS SWITCH LEVER that is connected to the AUTO FOCUS SWITCH so you can install it on the new AUTO FOCUS SWITCH.

[8]To disconnect and remove the AUTO FOCUS SWITCH, bend the LOCKING TAB on the FOCUS MOTOR BRACKET until it is aligned with the hole in the AUTO FOCUS SWITCH.

Installing the AUTO-FOCUS SWITCH ASSEMBLY

Important

Align the 2 TABS on the AUTO-FOCUS SWITCH with the FOCUS MOTOR BRACKET, checking that the end of the AUTO-FOCUS LEVER engages with the CYCLE SOLENOID PLUNGER. After the AUTO-FOCUS SWITCH is in the correct position, bend the LOCKING TAB to hold the AUTO FOCUS SWITCH in place.

[1]Do the replacement procedure for the AUTO-FOCUS SWITCH in reverse order.

Replacing the FOCUS SHAFT ASSEMBLY - Auto Focus Models

Warning

Dangerous Voltage

[1]Disconnect the main power.

SM5440-1 – 18NOV97 21