Lexmark 522 setup guide

Page 22

If you have installed an optional Tri-Port Adapter, you can locally attach the printer with a serial cable. We recom- mend Lexmark part number 1038693 (50 ft). For details on LocalTalk or infrared connections, refer to the docu- mentation that shipped with the Tri-Port Adapter.

Note: All Windows operating systems support parallel cable connections. However, only the Windows 98/ Me and Windows 2000 operating systems support USB cable connections.

To attach the printer to a computer:

1 Make sure the printer, computer, and any other attached devices are turned off and unplugged.

2 Connect the printer to the computer using a parallel or USB cable.

–Use an IEEE-1284 compliant parallel cable to ensure that you can access all of your printer functions.

–Be sure to match the USB symbol on the cable to the USB symbol on the printer.

20

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Lexmark T522 Conventions Edition MayGetting started See Install paper options and printer Installing the 2000-sheet drawerInstalling a 250-sheet or 500-sheet drawer Installing a duplex unit Handhold Square hole Tab Round peg Page Operator panel overlay Lift open the envelope feeder connector door Install memory and option cards Accessing the printer system boardHold the shield by the tabs and lift it off Installing printer memory or flash memory Installing an optional firmware card Installing an option card Page Reattaching the shield and closing the doors Load print material Attach cables Page Page Verify printer setup Turning on the printer Printing a network setupReady Configure for TCP/IP Setting the printer IP addressVerifying IP settings Configure for Pull Printing ImageQuick Install printer drivers Windows PortsPrinting methods Novell Distributed Print Services Ndps Windows Supported connections Page 09H0401 H0000
Top Page Image Contents