Lexmark 522 setup guide Getting started

Page 3

Getting started

137.16 cm

(4.5 ft)

304.8 mm

304.8 mm

(12 in.)

(12 in.)

 

508 mm

304.8 mm

(20 in.)

(12 in.)

1 Select a well-ventilated place to set up your printer. Allow at least as much space as shown in the illustration. Make sure you have a sturdy, low table or the optional printer stand on which to set the printer.

Printer

CDs

2 Remove all items from the box except the printer. If any items are missing, contact the place where you bought the printer.

Handhold

Paper bail

and bracket

Power switch cover

Operator panel

500 sheet drawer Power cord overlay (non-English only)

Save the carton and packing material in case you need to repack the printer for ser- vice or storage.

Note: Leave the printer in the box until you are ready to install it. Then ask someone to help you lift the printer using the hand- holds.

Turn off the printer If your printer is already set up, make sure the printer power is off and the power cord and any cables are unplugged before installing any options.

Options compatibility Options compatible with the Lexmark T522TM printer are labeled with a colored triangle. Label locations are indicated in the illustrations in this book.

Troubleshooting If you encounter a problem while setting up the printer, refer to the Lexmark T522 Publications CD.

1

Image 3
Contents Lexmark T522 Edition May ConventionsGetting started See Installing the 2000-sheet drawer Install paper options and printerInstalling a 250-sheet or 500-sheet drawer Installing a duplex unit Handhold Square hole Tab Round peg Page Operator panel overlay Lift open the envelope feeder connector door Accessing the printer system board Install memory and option cardsHold the shield by the tabs and lift it off Installing printer memory or flash memory Installing an optional firmware card Installing an option card Page Reattaching the shield and closing the doors Load print material Attach cables Page Page Turning on the printer Printing a network setup Verify printer setupReady Setting the printer IP address Configure for TCP/IPVerifying IP settings Configure for Pull Printing ImageQuick Windows Ports Install printer driversPrinting methods Novell Distributed Print Services Ndps Windows Supported connections Page 09H0401 H0000