Lexmark 522 setup guide Handhold Square hole Tab Round peg

Page 8

Setting up the printer In order to ensure adequate clearance when installing sys- tem board options, see “Install memory and option cards” starting on page 10 before you position the printer if:

You plan to install memory or option cards

and

You will have less than 605.6 mm (24 in.) clear- ance on the left side of the printer.

CAUTION! Make sure your fingers are not under the printer when you set it down.

1 Ask someone to help you lift the printer by the hand- holds and lower it onto the duplex unit, optional drawer, table or printer cabinet.

The tab, round peg, and square holes on top of any drawer or the duplex unit help you seat the printer so the edges are aligned properly. Make sure the printer is securely in place.

Handhold

Square hole

Tab

Round peg

2 Remove the print cartridge packaging.

a Push the release latch and open the printer upper front door.

b Grasp the print cartridge by the hand grip and pull the print cartridge up and out.

Print cartridge

6

Image 8
Contents Lexmark T522 Conventions Edition MayGetting started See Install paper options and printer Installing the 2000-sheet drawerInstalling a 250-sheet or 500-sheet drawer Installing a duplex unit Handhold Square hole Tab Round peg Page Operator panel overlay Lift open the envelope feeder connector door Install memory and option cards Accessing the printer system boardHold the shield by the tabs and lift it off Installing printer memory or flash memory Installing an optional firmware card Installing an option card Page Reattaching the shield and closing the doors Load print material Attach cables Page Page Verify printer setup Turning on the printer Printing a network setupReady Configure for TCP/IP Setting the printer IP addressVerifying IP settings Configure for Pull Printing ImageQuick Install printer drivers Windows PortsPrinting methods Novell Distributed Print Services Ndps Windows Supported connections Page 09H0401 H0000