Lexmark 522 setup guide Verifying IP settings Configure for Pull Printing ImageQuick

Page 26
Repeat step 6 to set the IP Gateway.
Repeat step 6 to set the IP Netmask.

Verifying the

IP settings

Configure for Pull Printing (ImageQuick)

6 Change the address by pressing Menu to increase (or decrease) each number. Press Select to move to the next segment. Press Select when you are finished.

The message Saved appears briefly.

7 Press Menu until you see Set IP Netmask, and then press Select.

8

9 Press Menu until you see Set IP Gateway, and then press Select.

10

11 When you are finished, press Go to return the printer to the Ready state.

1 Print another network setup page and make sure the IP Address, Netmask, and Gateway are what you expected.

Use the information in “Printing a network setup page” on page 21 if you need help.

2 Ping the printer and verify that it responds.

For example, at a command prompt on a network computer type “ping” followed by the new printer IP address:

ping xxx.xxx.xxx.xx

If the printer is active on the network, you will receive a reply.

If your printer has an optional ImageQuick™ firmware card installed, you can configure for Pull Printing once an IP address has been assigned to your printer.

For detailed configuration instructions, refer to the online documentation on the ImageQuick CD. The ImageQuick CD is shipped with printers that have the optional ImageQuick firmware card preinstalled, and also with the firmware card if you purchased it separately.

24

Image 26
Contents Lexmark T522 Conventions Edition MayGetting started See Install paper options and printer Installing the 2000-sheet drawerInstalling a 250-sheet or 500-sheet drawer Installing a duplex unit Handhold Square hole Tab Round peg Page Operator panel overlay Lift open the envelope feeder connector door Install memory and option cards Accessing the printer system boardHold the shield by the tabs and lift it off Installing printer memory or flash memory Installing an optional firmware card Installing an option card Page Reattaching the shield and closing the doors Load print material Attach cables Page Page Verify printer setup Turning on the printer Printing a network setupReady Configure for TCP/IP Setting the printer IP addressVerifying IP settings Configure for Pull Printing ImageQuick Install printer drivers Windows PortsPrinting methods Novell Distributed Print Services Ndps Windows Supported connections Page 09H0401 H0000