Lexmark 522 setup guide

Page 9

cPull on each end of the plastic, V-shaped piece and then pull the packaging material straight out. Discard all packaging material.

dAlign the slides on the print cartridge with the slots on the print cartridge cradle. Use the col- ored arrows inside the printer for placement.

eGuide the print cartridge down as it drops and snaps into place.

fClose the upper front door.

3 Attach decals to any optional paper trays.

Decals showing the number “1” are on your printer and the standard input tray. These decals keep the standard input tray paired with the printer.

If you purchased optional drawers, you received a sheet of decals.

Peel the decals from the sheet and attach them to the recessed areas on the drawer and the matching tray.

7

Image 9
Contents Lexmark T522 Edition May ConventionsGetting started See Installing the 2000-sheet drawer Install paper options and printerInstalling a 250-sheet or 500-sheet drawer Installing a duplex unit Handhold Square hole Tab Round peg Page Operator panel overlay Lift open the envelope feeder connector door Accessing the printer system board Install memory and option cardsHold the shield by the tabs and lift it off Installing printer memory or flash memory Installing an optional firmware card Installing an option card Page Reattaching the shield and closing the doors Load print material Attach cables Page Page Turning on the printer Printing a network setup Verify printer setupReady Setting the printer IP address Configure for TCP/IPVerifying IP settings Configure for Pull Printing ImageQuick Windows Ports Install printer driversPrinting methods Novell Distributed Print Services Ndps Windows Supported connections Page 09H0401 H0000