Lexmark 522 setup guide Install memory and option cards, Accessing the printer system board

Page 12

Step 2: Install memory and option cards

Accessing the printer system board

You can customize your printer memory capacity and con- nectivity by adding optional cards. The instructions in this section help you install any of the following options:

Printer memory

Flash memory

Tri-Port Adapter

USB/Parallel 1284-C Interface Card

Parallel 1284-C Interface Card

MarkNet™ internal print servers (also called internal network adapters or INAs)

Hard disk

Optional firmware card

You must access the printer system board to install printer memory, flash memory, or an option card.

1 Make sure the printer power is off, the printer power cord is unplugged, and all cables are disconnected from the back of the printer.

2 Press the release latches to open the upper and lower front doors.

10

Image 12
Contents Lexmark T522 Conventions Edition MayGetting started See Install paper options and printer Installing the 2000-sheet drawerInstalling a 250-sheet or 500-sheet drawer Installing a duplex unit Handhold Square hole Tab Round peg Page Operator panel overlay Lift open the envelope feeder connector door Install memory and option cards Accessing the printer system boardHold the shield by the tabs and lift it off Installing printer memory or flash memory Installing an optional firmware card Installing an option card Page Reattaching the shield and closing the doors Load print material Attach cables Page Page Verify printer setup Turning on the printer Printing a network setupReady Configure for TCP/IP Setting the printer IP addressVerifying IP settings Configure for Pull Printing ImageQuick Install printer drivers Windows PortsPrinting methods Novell Distributed Print Services Ndps Windows Supported connections Page 09H0401 H0000