Xerox Inkjet Printer manual Packing the printer for return to a Service Center

Page 71

Packing the printer for return to a Service Center

Should you need to return the printer for servicing, follow the packing instructions in this section

Note: Do not ship the power cord, printer cable, printer driver disks, user guide, print head and ink cartridges, or storage box unless instructed to do so.

1.Remove the print cartridge and place it in the print head storage box.

2.Close the printer cover and remove the paper output shelf.

3.Disconnect the power cord and the printer cable.

4.If you have the original box, use the original packing material, and go to step 10. If you do not have the original box, continue with step 5.

5.Completely wrap the printer in two layers of bubble wrap (minimum thickness of 12.3 mm or 0.5”) and tape the bubble wrap to keep it in place.

6.Select a corrugated box large enough to allow at least 50.8 mm (2”) between the bubble-wrapped printer and the walls of the box. Make sure the strength of the box is at least 275-lb. test.

7.Fill the bottom of the box with 75 to 100 mm (2” to 3”) of loose fill.

8.Place the bubble-wrapped printer in the center of the box.

63

Image 71

Contents DocuPrint C8 Ink Jet Printer Publication number 701P30101 Customer Support Page Contents Selecting and ordering supplies Troubleshooting the printerPrinting DOS in a Window Index Page Introduction Generating Floppy Disks from your CD Safety notesPage Page Page Page Directions for On-Line Registration Printer RegistrationUnderstanding the printer’s features Hardware features Inside view of DocuPrint C8 Printer Back view of DocuPrint C8 Printer Normal Printer Operation Control panel OperationLED Blinking Intermittently 0.2 sec On, 1.4 sec Off LED On ContinuouslyFeature Specification Printer specificationsFeatureSpecification System Requirements Recommended Possible Printable area / MarginsDownloading the Windows NT 4.0 Printer Driver Using the printer settingsLanguage field, select US English or French From the Printers folder for Windows NT Accessing printer settingsFrom a Windows software application From the Printers folder for Windows 95/98Paper/Output Property Page Print quality Paper sizePaper type Save As button Photo quality Resolution isSaved settings Device mimic printer illustration in lower left corner Default AllDelete button Status buttonLayout Property Print sheets Default buttonNumber of sheets Print crop marksSelect Sheets Clear All Cancel HelpNone Defaults buttonImages per sheet Print bordersMirror Image Image Quality Property Saturation ContrastBlue DefaultsRed GreenAbout Status Property Page Restart Now printingCopy Percent completeMaintenance Property Page ∙ Color ink cartridge ∙ Previously used print cartridgeAlign Clean∙ New print cartridge Test Print the Alignment Test PatternChecking the documents in the print queue Troubleshooting the printer Cause Suggested Solution Printed document is blank Cause Suggested Solution Document prints slowly Document sent to the printer does not print Front Panel LED is on continuously Installation/Reference Guide forPage Front Panel LED is blinking intermittently Front Panel LED is blinking slowlyPrint is blurry or jagged vertical lines appear Printed image is clipped or off the edge of the media Cause Suggested Solution Cause Suggested Solution Print is faint or missing Ink is smeared on the printed pages Print quality of transparencies is poor Color variations appear in large areas of color Paper is not feeding properly Paper does not stack neatly in the paper output shelf Packing the printer for return to a Service Center Printer Selecting and ordering supplies Description Reorder Number Paper weightsCartridges and print heads Selecting plain paperSelecting specialty print media Selecting envelopes Selecting labelsSelecting transparencies Selecting banner paperPrinting DOS in a Window Windows NT Index