Xerox Complete Guide to Powering On and Off Your 8850 Printer

2.Powering on and off

This chapter describes the procedures for powering on and powering off. It also describes the power consumption modes.

Powering on

Circuit breaker switch

Printer power switch

To power on:

1.Switch the circuit breaker to the On (I) position. This turns on power to the AccXES controller. The AccXES controller does not have a separate power switch.

2.Switch the printer power switch to the On (I) position. This turns on power to the printer.

NOTE: During the warm-up cycle, the message display provides a "printer is warming up" message and decreasing fuser warm-up codes of L9 to L0. When the warm-up completes, the printer is on-line and ready to print. The message display indicates, "XES SYNERGIX 8850 IDLE."

XES SYNERGIX 8850 PRINTER OPERATOR MANUAL 7