Xerox 8850 manual Powering off, Power consumption modes

POWERING ON AND OFF

Powering off

To power off:

1.Switch the circuit breaker to the Off (O) position. This turns off power to the AccXES controller. The AccXES controller does not have a separate power switch.

2.Switch the printer power switch to the Off (O) position. This turns off power to the printer.

Power consumption modes

The printer has four power consumption modes. They are:

Running The printer is capable of making prints immediately in this mode. When in this mode, the message display indicates that the printer is "PRINTING."

Ready The printer enters this mode 2 to 30 seconds after completion of a print. When in this mode, the message display indicates that the printer is "IDLE."

Power saver The printer enters this mode to reduce energy consumption after a specified period of inactivity since the completion of the last print. This time period is user-programmable. The range is 5 to 50 minutes. See the "Off-line Setup Menu" chapter for more information about setting the power saver timer.

NOTE: When the printer is in this mode, the fuser is at low power. The printer needs to warm up from an L3 status code before being ready to print.

Rest The printer enters this mode to minimize energy consumption after a specified period of inactivity since entering power saver mode. This time period is user-programmable. The range is 15 to 150 minutes. See the "Off-line Setup Menu" chapter for more information about setting the rest mode timer.

NOTE: When the printer is in this mode, the fuser is off. The printer needs to warm up from an L9 status code before being ready to print.

8 XES SYNERGIX 8850 PRINTER OPERATOR MANUAL