Xerox 8850 manual Japan, Usa

Page 6

EMC NOTICES

Japan

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

Changes or modifications to this equipment not specifically approved by Fuji Xerox Limited may void the user’s authority to operate this equipment.

Shielded cables must be used with this equipment to maintain compliance with the Voluntary Control Council for Interference by Information Technology Equipment regulations.

USA

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Changes or modifications to this equipment not specifically approved by the Xerox Corporation may void the user’s authority to operate this equipment.

Shielded cables must be used with this equipment to maintain compliance with FCC regulations.

iv

XES SYNERGIX 8850 PRINTER OPERATOR MANUAL

Image 6
Contents XES Synergix Printer Operator Manual USA 701P36587 7/2001Table of contents Problem solving European Union EMC noticesAustralia/New Zealand CanadaJapan USASafety notes Safety Notes Organization and content of this manual IntroductionTerminology used in this manual Problem solvingTechnical data Conventions used in this manualPrinter overview Printer orientationMain components Printer Overview Control panel Language key This page has been intentionally left blank Powering on and off Powering onPowering off Power consumption modesWhen a media roll empties MediaLoading the roll media Media Media Media Changing the roll media size and type Media Using the cut sheet feed-in shelf Automatic media roll switching Media storage tipsThis page has been intentionally left blank Off-line Setup Menu Setup Menu optionsPrinter Menu Printer Menu options Option Sub-option FunctionPrinter Menu options Option Sub-option FunctionAccessing the Printer Menu Enabling or disabling the audible indicatorsSetting the timers Adjusting the print densitySpecifying the finisher configuration type Performing printer diagnosticsPrinting a test plot Viewing the recent fault log Displaying the billing meter countsThis page has been intentionally left blank When the toner cartridge needs replacement CareReplacing the toner cartridge Care Care Replacing the toner waste bottle Care Cleaning the printer surface Supply order procedure Ordering suppliesSupply order list Problem solving Clearing media jamsFuser area jam Problem Solving Cutter area jam Roll media drawer jams Problem Solving Problem Solving Status codes Status code table ExplanationError messages Error message table Error Message Problem SolutionProblem solving table Problem-solving table Condition Causes Suggested SolutionsCalling for service This page has been intentionally left blank Product specifications Hardware specificationsMaximum prints per minute Europe/Central and South America Media specifications Media specificationsSpace requirements
Related manuals
Manual 162 pages 21.8 Kb