MEDIA
11.Squeeze the lever at the end of the media roll support tube and position the tube until the size indicators on the tube match the size of the roll.
•For example, if the media roll is 36 inches, the ends of the media roll should be at the
12.Place the new media roll into the media drawer so that the lead edge of the paper is on the underside of the roll and toward the printer.
13.Position the media roll support tube so that the ends of the tube rest within the support rollers at the sides of the drawer.
•Ensure that the tube falls into place within the support rollers.
14.Remove the tape from the lead edge of the media roll.
15.If the lead edge of the media roll contains debris from the adhesive or is torn or uneven, trim the lead edge.
NOTE: Trimming is not usually necessary for a new roll of media.
12 | XES SYNERGIX 8850 PRINTER OPERATOR MANUAL |