Xerox 96 NPS manual Frequent misfeeds

Page 23

CLEARING PAPER MISFEEDS AND JAMS

7.Slide the tray back into the printer until the tray latches and press the Continue button to resume printing.

8.Discard any pages sent to the sample tray or unused stacker tray when the paper jam was detected.

Note: If the 96/4635/180 NPS does not continue printing after a paper tray fault or after paper is loaded, open then close the tray. The system should resume printing.

Frequent misfeeds

Frequent misfeeds may be caused by a glazed feed belt, especially if one tray feeds the same kind of paper better than another tray does. (Glazing is caused by a buildup of the chemicals found on most papers.)

If you suspect that the belt is glazed, try cleaning it with film remover obtained from your service representative.

Caution: Clean the feed belt only to correct misfeeds, not as routine maintenance. Because the belt is rubber, frequent cleaning dries it out and makes it fail prematurely.are or software.

1.Clear any misfeeds that have occurred, but do not latch the paper feeder assembly. If necessary, unlatch it by pressing down on the bright green lever on the right side of the paper tray.

2.Lightly moisten a lint-free towel with film remover and thoroughly wipe the outside surface of the feed belt in the same direction as the ribs on the belt. (Wiping from side to side might

XEROX DOCUPRINT 96/4635/180 NPS TROUBLESHOOTING GUIDE

5-3

Image 23

Contents Version 7.1 August 2000 721P86651 Page Ozone information Laser safetyOperation safety Xerox Docuprint 96/4635/180 NPS Troubleshooting Guide Table of contents Correcting stacking problems System unresponsive Index About this guide ContentsIntroduction Conventions DocuPrint NPS Interactive Customer Documentation CD Related publicationsPage Information to have on hand when calling for service Calling for serviceEnabling and disabling the modem for remote service Fault masking Fault List screen Troubleshooting Xerox Client Software installation Troubleshooting Xerox Client Software Installation PASSWORDS=ON at Troubleshooting a Novell implementationPserver problems Problem Probable Cause Resolution Problem Probable Cause Resolution Rprinter problems Problem Probable Cause Resolution Page Clearing paper misfeeds and jams Clearing a feeder tray faultClearing Paper Misfeeds and Jams Frequent misfeeds Clearing paper jams Checking job integrity following a paper jam Fault InstructionsArea Printer areasArea Area Area Area Area Area Area Area Area Clearing bypass transport paper jams Area Measuring the paper curl Paper curl and paper jamsDecurler lever Adjusting the decurler leverPaper curl chart Arguments None Using sample documentsListing and printing sample documents List Sample DocumentsArguments Document Print Sample DocumentPS-oplist sample documents Using Sample Documents Page Installing the custom transfer assist blade Adjusting print quality and speedCorrecting skewed printing Adjusting the registration transport roll leversAdjusting Print Quality and Speed Measuring performance Calculating throughput Enter Start Printing Minimizing the start-up latency 99995163.ps, November 19, 1996 35222 pm PST Dpi versus 600 dpi performance Proprietary PostScript extensions Setting page orderProduct features that affect print quality Gray shading-settransfer and transfer function Device-dependent operatorsGray shading-setscreen and setcolorscreen Scan conversion-fill, eofill, and stroke Settransfer, or SetcolortransferSmooth curves-setflat Invisible strokes-0 setlinewidthSymptom Probable cause Action Correcting stacking problemsPage System unresponsive Configuring and Managing the System forPage Numerics IndexIndex