Belkin F1DA108PEA, F1DA116PEA, F1DA104PEA user manual Connect the Computer

Page 13

Installation

Connect the Computer:

1.Using an OmniView KVM Cable (Belkin part# F3X1105b-XX, plug in the male VGA connector to the VGA port on the computer. Connect the other end (the female connector) of the VGA cable to the back of the PRO2 PS/2 labeled “VGA 01”.

2.Connect the PS/2 keyboard and PS/2 mouse connectors of the cable to the keyboard and mouse ports on the computer. Connect the other ends of the cables to the keyboard and mouse ports located directly underneath VGA 01 on the PRO2 PS/2 (Belkin part # F3X1105b-XX).

��	��	��	��	��	��	��	��	��
	��	��	��	��	��	��	��	��

3. Repeat steps 1 and

2 for each additional PS/2 computer you wish to connect.

1

2

3

4

5

6

7

8

9

10

section

11

Image 13

Contents PRO2 PS/2 Table of Contents Overview Package ContentsOverview LED Display Front-Panel Push ButtonSeven-Segment LED Display Equipment Requirements CablesKeyboards OmniView All-In-One PRO Series PlusMice MonitorSide View of the PRO2 PS/2 Back View of the PRO2 PS/2 Front View of the PRO2 PS/2Port LED Indicators Max. Resolution 2048x1536@85Hz Bandwidth 400MHzDimensions WeightPre-Configuration Where to Place the PRO2 PS/2 InstallationCable Distance Requirements Step-by-Step Installation Guide InstallationConnect the Console Single PRO2 PS/2 InstallationConnect the Computer Connecting Multiple PRO2 PS/2s Daisy-Chaining Example Bank DIP Switch Configuration ChartBefore You Begin Connecting the Master Switch to the First Slave SwitchAdding Additional Slave Units Connecting the Computers Example of Daisy-Chain ConfigurationPowering up the Systems Using your PRO2 PS/2Selecting a Computer Using Keyboard Hot Key Commands Using your PRO2 PS/2Selecting a Computer Using Direct-Access Port Selectors AutoScan ModeBank Up and Bank Down Scroll Buttons Keyboard Hot Key Commands On-Screen Display Menu Control AutoScan Time To update the firmware, you will need the following itemsOSD Display Time Updating FirmwareSetting the PRO2 PS/2 into Flash Mode Connecting ComputersDIP Switch Firmware OmniView KVM Switches Belkin KVM switches and accessoriesBelkin KVM switches and accessories OmniView All-In-One KVM Cables PRO2 PS/2 series FAQs PRO2 PS/2 series FAQs PRO2 PS/2 series FAQs Am getting a black screen on my monitor TroubleshootingMouse Mouse is lost when I switch to a different port TroubleshootingComputer boots up, but the mouse does not work Mouse is not detected at boot-upBelkin Components Limited Three-Year Product Warranty Warranty, FCC, CE, Ices StatementFCC Statement F1DA104P, F1DA108P, F1DA116PWarranty, FCC, CE, Ices Statement Belkin GmbH