Belkin F1DA116PEA, F1DA108PEA, F1DA104PEA user manual Mouse is not detected at boot-up

Page 33

Troubleshooting

The mouse is not detected at boot-up.

• Check the cables and make sure that they are inserted correctly.

The computer boots up, but the mouse does not work.

•Make sure the mouse is plugged in properly.

•Make sure the mouse works when directly plugged into the computer. Rebooting may be necessary when trying this.

•Try a different mouse.

When I switch from one port to another, mouse movement is completely erratic.

•Make sure you do not have more than one mouse driver installed. Make sure that the driver is either for a standard PS/2 mouse or a Microsoft computer-compatible PS/2 mouse.

•Make sure you do not have any mouse drivers loaded in your CONFIG. SYS or AUTOEXEC.BAT files.

•Avoid moving the mouse or pressing the mouse button when switching ports on the PRO2 PS/2.

•You can reset the mouse and resume proper mouse movement simply by unplugging the mouse from the front of the PRO2 PS/2 for about 2-3 seconds, and then plugging it in again.

1

2

3

4

5

6

7

8

9

10

section

31

Image 33

Contents PRO2 PS/2 Table of Contents Overview Package ContentsOverview LED Display Front-Panel Push ButtonSeven-Segment LED Display Equipment Requirements CablesKeyboards OmniView All-In-One PRO Series PlusMice MonitorSide View of the PRO2 PS/2 Back View of the PRO2 PS/2 Front View of the PRO2 PS/2Port LED Indicators Max. Resolution 2048x1536@85Hz Bandwidth 400MHzDimensions WeightInstallation Pre-Configuration Where to Place the PRO2 PS/2Cable Distance Requirements Step-by-Step Installation Guide InstallationConnect the Console Single PRO2 PS/2 InstallationConnect the Computer Connecting Multiple PRO2 PS/2s Daisy-Chaining Example Bank DIP Switch Configuration ChartConnecting the Master Switch to the First Slave Switch Before You BeginAdding Additional Slave Units Connecting the Computers Example of Daisy-Chain ConfigurationPowering up the Systems Using your PRO2 PS/2Selecting a Computer Using Keyboard Hot Key Commands Using your PRO2 PS/2AutoScan Mode Selecting a Computer Using Direct-Access Port SelectorsBank Up and Bank Down Scroll Buttons Keyboard Hot Key Commands On-Screen Display Menu Control AutoScan Time To update the firmware, you will need the following itemsOSD Display Time Updating FirmwareConnecting Computers Setting the PRO2 PS/2 into Flash ModeDIP Switch Firmware OmniView KVM Switches Belkin KVM switches and accessoriesBelkin KVM switches and accessories OmniView All-In-One KVM Cables PRO2 PS/2 series FAQs PRO2 PS/2 series FAQs PRO2 PS/2 series FAQs Am getting a black screen on my monitor TroubleshootingMouse Mouse is lost when I switch to a different port TroubleshootingComputer boots up, but the mouse does not work Mouse is not detected at boot-upBelkin Components Limited Three-Year Product Warranty Warranty, FCC, CE, Ices StatementFCC Statement F1DA104P, F1DA108P, F1DA116PWarranty, FCC, CE, Ices Statement Belkin GmbH