Belkin F1DA108PEA Using your PRO2 PS/2, Selecting a Computer Using Keyboard Hot Key Commands

Using your PRO2 PS/2

Selecting a Computer Using Keyboard Hot Key Commands:

Switch to the next or previous port with simple keyboard key sequences using the “Scroll Lock” key and either the up or down arrow keys. To send commands to the PRO2 PS/2, the “Scroll Lock” key must be pressed twice within two seconds. The PRO2 PS/2 will beep, confirming that it is in hot key mode. Next, press the up or down arrow keys, and the PRO2 PS/2 will switch to either the prior port or the next port.

�	�	�	�
Switch to next active port—Down arrow		Switch to next active port—Up arrow

With a single-switch configuration (no daisy-chained switches), you can switch directly to any port by entering the two-digit number of the port you wish to access. For example, if you press “Scroll Lock”, “Scroll Lock”, “02”, the PRO2 PS/2 will switch to the computer on port 2 located on BANK 00.

� �

Switch to BANK 00, Port 2—(02)

Note: You will have approximately five seconds to complete each hot key sequence.

With daisy-chain switch configuration, you can switch between BANKs by pressing “Scroll Lock”, “Scroll Lock”, “Page Up”, to switch to the previous BANK. Press “Scroll Lock”, “Scroll Lock”, “Page Down”, to switch to the next BANK.

�	�	�����	�	�	�����
		��			����
Switch to previous BANK—Page Up			Switch to next BANK— Page Down

1

2

3

4

5

6

7

8

9

10

section

17