Belkin F1DA108PEA Before You Begin, Connecting the Master Switch to the First Slave Switch

Page 16

section

1

2

3

4

5

6

7

8

9

10

Installation

Before You Begin:

1.Make sure that all computers are powered off and that each PRO2 PS/2 has been assigned a unique BANK address.

2.Place Master and Slave switches in the desired location. Make sure all are turned off and unplugged from the power source.

3.Connect the Console monitor, keyboard, and mouse to the Console ports of the Master switch or Bank 00, as described previously in this installation guide.

Connecting the Master Switch to the First Slave Switch:

4.Using the daisy-chain cable (F1D108-CBL), connect one end of the cable to the “Master Input/Slave Output” port on the Master switch (BANK 00).

5.Connect the other end of the daisy-chain cable to the “Master Input/Slave Output” port of the first Slave switch (BANK 01).

Adding Additional Slave Units:

6.Using the daisy-chain cable (F1D108-CBL), connect one end of the cable to the available daisy-chain port labeled “Slave Input” on the Slave switch (for example, BANK 01).

7.Connect the other end of the daisy-chain cable to the “Master Input/Slave Output” port of the Slave switch that you are adding (for example, BANK 02).

8.Repeat steps 6 and 7 for additional PRO2 PS/2s you wish to daisy- chain together.

14

Image 16

Contents PRO2 PS/2 Table of Contents Package Contents OverviewOverview Front-Panel Push Button LED DisplaySeven-Segment LED Display Equipment Requirements CablesOmniView All-In-One PRO Series Plus KeyboardsMice MonitorSide View of the PRO2 PS/2 Front View of the PRO2 PS/2 Back View of the PRO2 PS/2Max. Resolution 2048x1536@85Hz Bandwidth 400MHz Port LED IndicatorsDimensions WeightPre-Configuration Where to Place the PRO2 PS/2 InstallationCable Distance Requirements Installation Step-by-Step Installation GuideSingle PRO2 PS/2 Installation Connect the ConsoleConnect the Computer Connecting Multiple PRO2 PS/2s Daisy-Chaining Bank DIP Switch Configuration Chart ExampleBefore You Begin Connecting the Master Switch to the First Slave SwitchAdding Additional Slave Units Example of Daisy-Chain Configuration Connecting the ComputersUsing your PRO2 PS/2 Powering up the SystemsUsing your PRO2 PS/2 Selecting a Computer Using Keyboard Hot Key CommandsSelecting a Computer Using Direct-Access Port Selectors AutoScan ModeBank Up and Bank Down Scroll Buttons Keyboard Hot Key Commands On-Screen Display Menu Control To update the firmware, you will need the following items AutoScan TimeOSD Display Time Updating FirmwareSetting the PRO2 PS/2 into Flash Mode Connecting ComputersDIP Switch Firmware Belkin KVM switches and accessories OmniView KVM SwitchesBelkin KVM switches and accessories OmniView All-In-One KVM Cables PRO2 PS/2 series FAQs PRO2 PS/2 series FAQs PRO2 PS/2 series FAQs Troubleshooting Am getting a black screen on my monitorTroubleshooting Mouse Mouse is lost when I switch to a different portMouse is not detected at boot-up Computer boots up, but the mouse does not workWarranty, FCC, CE, Ices Statement Belkin Components Limited Three-Year Product WarrantyFCC Statement F1DA104P, F1DA108P, F1DA116PWarranty, FCC, CE, Ices Statement Belkin GmbH