6
IP Setup
This section describes the IP set up & configuration of the ePowerSwitch System when you connect it to the network.
There are four different ways to setup ePowerSwitch.
1.Setup IP address via Ethernet port using the ARP command (first time only), then use a Web browser to setup all the parameters. This is the easiest way to setup.
2.Setup via serial RS232 port using terminal software, e.g. Windows HyperTerminal.
3.Setup via USB port using ePowerSwitch USBSetup software (USBSetup software included).
4.Setup IP address by using ARP command (first time only), then use telnet command to do the rest of the setup. The setup interface is the same as serial RS232 port setup.
5.Setup IP address via Ethernet cascaded cable.
1.Setup via Ethernet port
Before setup you need:
1.IP address: Get a valid IP address from administrator.
2.MAC address: Find MAC address on the front panel of the Web Card.
3.Default password: admin
6