The following steps guide you in connecting the ePowerSwitch System through the Ethernet port
1.Connect the Ethernet port to the network with the Ethernet cable.
2.Using the following settings in the text mode :
c:\>arp
??216.87.151.196 is the IP address
??
Use ARP command to setup IP address only for the first time and the IP address is temporarily.
3.Use a Web browser to enter in and configure all ePowerSwitch network parameters with the IP address you setup by ARP command.
Use Web browser to set IP, gateway and subnet
1.Select “Network” in the SERVER category.
2.Fill out the blank and click “save” button.
3.Select “Save&Restart”, then click “Save and Restart” button to save network information into Web Card and reboot it.
4.Web Card needs about 30 seconds to reboot. Then IP setup procedure is done. ePowerSwitch works now.
7