Belkin F1D001 user manual

Page 14

10

3.Press OK if you have the Windows Communications screen or accept your communication settings in the terminal emulation package. The terminal/PC is now configured to communicate with the ePowerSwitch.

4.Approximately three seconds after you turn on AC power, the terminal displays “Check u- dram…”. Within 5 seconds, press “/” when you see “Waiting five seconds…” to enter console configuration.

You are now ready to configure the ePowerSwitch. Refer to the following Configuration section for a more detailed discussion.

10

Image 14

Contents EPowerSwitch Conventions Used In This Guide Table of Contents Appendix EPowerSwitch Features IntroductionSwitch Status LEDsRJ 11 Jacks EPowerSwitch System Unit EPowerSwitch System PackageEPowerSwitch System Package Contents One 3.5 Diskettes IP Setup Setup via Ethernet port Use Web browser to set IP, gateway and subnet Setup via serial port Page Page Serial or Telnet Configuration Use terminal to set IP, gateway and subnetIP Address for the ePowerSwitch System and More Setup via USB port Page Telnet Options Setup via Ethernet Cascaded Cable Ethernet Cascaded Cable. Not EncloseConfiguration PPP ConfigurationRemote operation procedure User Management Software Update EPowerSwitch Configuration Page Scheduled shutdown Verify The ePowerSwitch Operation SetRS232 Serial Port Console Upgrade Upgrade FirmwareTftp Upgrade User data are lost Telephone access interface Telephone InterfaceEPowerSwitch Function ID Address Outlet 01-16 Page Communities AppendixReference IP AddressesSubnetting and Subnet Masks Value Purpose Subnet maskingRouting and Filtering Gateways Glossary NMS Network Management StationPage Troubleshooting