16
| adapter you may access the configuration menu as if you were |
| directly attached to it via the configuration port. |
| Moving cursor in telnet session is tricky. You need to select |
| VT100 cursor which is under Terminal Preferences |
| VT100 Arrows . After this setup, moving around menu system |
| is actually easier than in console setup mode. |
|
|
Note: | You must have previously configured at least the IP |
| address and router information locally in order to |
| successfully make a Telnet connection. |
|
|
5.Setup via Ethernet Cascaded Cable
Before setup you need:
1.IP address: Get a valid IP address from administrator.
2.Ethernet Cascaded Cable. (Not Enclose)
The following steps guide you in connecting the ePowerSwitch System through the Ethernet port
1.Assign your PC’s IP address to dedicated IP address - 216.87.151.1
2.Connect the ePowerSwitch’s Ethernet port and PC’s network port with Ethernet cascaded cable.
3.Enter ePowerSwitch web default IP address- 216.87.151.196 by web browser, then Use Web browser to set IP, gateway and subnet.
16