Belkin F1D001 user manual

Page 13

The following steps guide you in connecting the ePowerSwitch System through the serial port

1.Connect the RS232 port to a dumb terminal/PC with RS232 cable.

2.Setup terminal software

1.Open terminal software; select “Property” in “File” category.

2.Setup as following image.

9

Image 13

Contents EPowerSwitch Conventions Used In This Guide Table of Contents Appendix Introduction EPowerSwitch FeaturesStatus LEDs SwitchRJ 11 Jacks EPowerSwitch System Package Contents EPowerSwitch System PackageEPowerSwitch System Unit One 3.5 Diskettes Setup via Ethernet port IP SetupUse Web browser to set IP, gateway and subnet Setup via serial port Page Page Use terminal to set IP, gateway and subnet Serial or Telnet ConfigurationIP Address for the ePowerSwitch System and More Setup via USB port Page Telnet Options Ethernet Cascaded Cable. Not Enclose Setup via Ethernet Cascaded CablePPP Configuration ConfigurationRemote operation procedure User Management Software Update EPowerSwitch Configuration Page Scheduled shutdown Set Verify The ePowerSwitch OperationTftp Upgrade Upgrade FirmwareRS232 Serial Port Console Upgrade User data are lost Telephone Interface Telephone access interfaceEPowerSwitch Function ID Address Outlet 01-16 Page Reference AppendixCommunities IP AddressesValue Purpose Subnet masking Subnetting and Subnet MasksRouting and Filtering Gateways NMS Network Management Station GlossaryPage Troubleshooting