Belkin F1D001 user manual Telnet Options

Page 19

3.USB setup is straightforward once the PC has successfully detected USB device. See the following figure.

You need to run Device Update & Restart before closing

4.Telnet Options

You can also Telnet to the IP address of the ePowerSwitch System after it has been installed on your network. Once you have successfully established a Telnet connection with the

Image 19

Contents EPowerSwitch Conventions Used In This Guide Table of Contents Appendix Introduction EPowerSwitch FeaturesStatus LEDs SwitchRJ 11 Jacks EPowerSwitch System Package Contents EPowerSwitch System PackageEPowerSwitch System Unit One 3.5 Diskettes Setup via Ethernet port IP SetupUse Web browser to set IP, gateway and subnet Setup via serial port Page Page Use terminal to set IP, gateway and subnet Serial or Telnet Configuration IP Address for the ePowerSwitch System and More Setup via USB port Page Telnet Options Ethernet Cascaded Cable. Not Enclose Setup via Ethernet Cascaded CablePPP Configuration ConfigurationRemote operation procedure User Management Software Update EPowerSwitch Configuration Page Scheduled shutdown Set Verify The ePowerSwitch OperationTftp Upgrade Upgrade FirmwareRS232 Serial Port Console Upgrade User data are lost Telephone Interface Telephone access interfaceEPowerSwitch Function ID Address Outlet 01-16 Page IP Addresses AppendixReference CommunitiesValue Purpose Subnet masking Subnetting and Subnet MasksRouting and Filtering Gateways NMS Network Management Station GlossaryPage Troubleshooting