24
Verify The ePowerSwitch Operation
1.After you complete all configuration settings and connect the ePowerSwitch System to the network, check the LINK status.
Power and Link lights should be on all the times. Collision light turns on occasionally.
2.PING the ePowerSwitch System. Issue a PING command from the NMS (Network Management Station).
a)If you do not get a response, check the card ’s network connection and IP address.
3.Test the adapter with an NMS. Perform a “get” and a
“set.”
a)If the get or set commands fail, check the ePowerSwitch System access controls. The manager must have read permission to execute a get command successfully and read/write permission to execute a set command successfully.
(See Configuring the NMS section for a detailed discussion.)
Your ePowerSwitch is now installed and
completely functional.
24