MatrixPRO-II DVI 16x16 Router
________________________________________________________________________
2Installation
2.1Initialization
▪Connect the provided AC power cord to AC power inlet and turn on the front panel switch
▪The unit starts the initialization process. The message “Starting” will be shown on the LCD display.
▪After 17~20 sec,
▪The unit is now ready to receive commands from the user.
Typically, the IP address of PC connected to the network is configured by a DHCP server. If the PC is connected directly to the router, the network server will not able to assign the IP address. In this case, network information for the PC should be set manually.
The default IP address of
2.2EDID Configuration
▪EDID (Extended Display Identification Data) is an information set that is provided by a display to describe its capabilities to a graphic source. It enables a graphic source to identify the connected display.
▪The information set includes: manufacturer, product type, phosphor or filter type, timings supported by the display, display size, luminance data and (for digital displays only) pixel mapping data.
▪Once the graphic source reads the information set (usually during the booting process), the EDID conveys the optimal format for a connected display.
▪The
▪The
1)Default Mode: default EDID information from the factory is loaded to an input port
2)Output Copy Mode: read EDID from any target display and copy to an input port
14
User’s Guide | Rev. 01 |