Barco 26-1302001-00 manual Operators Safety Summary

Page 4

MatrixPRO-II DVI 16x16 Router

________________________________________________________________________

Operators Safety Summary

The general safety information in this summary is for operating personnel.

Do not remove panels or covers

There are no user-serviceable parts within the unit. Removal of the top cover will expose dangerous voltages. To avoid personal injury, do not remove the top cover. Do not operate the unit without the cover installed.

Power Source

This product is intended to operate from a power source that will not apply more than 230 volts rms between the supply conductors or between both supply conductor and ground. A protective ground connection by way of grounding conductor in the power cord is essential for safe operation.

Grounding the Product

This product is grounded through the grounding conductor of the power cord. To avoid electrical shock, plug the power cord into a properly wired receptacle before connecting to the product input or output terminals. A protective-ground connection by way of the grounding conductor in the power cord is essential for safe operation.

Use of the Power Cord

Use only the power cord and connector specified for your product. Use only a power cord that is in good condition. Refer cord and connector changes to qualified service personnel.

Use of the Proper Fuse

To avoid fire hazard, use only the fuse having identical type, voltage rating, and current rating characteristics. Refer fuse replacement to qualified service personnel.

Do not Operate in Explosive Atmospheres

To avoid explosion, do not operate this product in an explosive atmosphere.

4

User’s Guide

Rev. 01

Image 4
Contents MatrixPRO-II DVI 16x16 Matrix Router User’s Guide Manual # RevisionUser’s Guide Rev Company Address Operators Safety Summary Terms in This Manual and Equipment Marking Cr6+ MatrixPRO-II DVI 16x16 Router Change History Table of Contents MatrixPRO-II DVI 16x16 Router Introduction Key FeaturesShipping Page Physical Description Front panel of MATRIXPRO-II DVI 16 XInstallation Initialization Edid ConfigurationEdid TCP/IP Control SetupLaunching Telnet RS-232 Launching HyperTerminal Unlink mode Front Panel Operation Link modeFunction mode Subnet Mask GatewayIP Address Edid Configure MAC AddressUDP Port Number Video GeneratorPage Hdcp Configure Hdcp ConfigureBaud Rate Reset ModeControl Lock Basic Setup PC Program OperationConnect Info Control Lock Mode Edid setupChannel Name NetworkOperation Input / output connection Output channel status Web control panel operation Commands Command input structureExamples of command inputs Link input and output Input and output statusMonitor output port setting Network settingEdid control command Hdcp Setting Baud rate setting for RS-232Control lock command Locking type and its Ascii dataFirmware update Power-On the MATRIXPRO-II DVI Page Page Hdcp notes Specifications Video InputsWarranty WarrantyContact Information Technical Support USA