Barco 26-1302001-00 instruction

MatrixPRO-II DVI 16x16 Router

________________________________________________________________________

===EDID Configure=== Entry EDID Configure? _1: Entry

1) Press input 1 key button to enter the EDID Configure Mode.

===EDID Configure=== Input: 01 Default Default Mode?

1: Y 2: N 3: << 4: >> 5: ∨ 6: ∧

The EDID configuration that is shown next to the input number on the LCD display is the current EDID mode

2)Select an input port by pressing input 5 or 6 key button.

3)Press input 3 or 4 key button to change EDID mode.

3-1) If you select Default Mode, default EDID will be restored for allocated inputs.

===EDID Configure=== Input: 01 Default Default Mode?

1:Y 2: N 3: << 4: >> 5: ∨ 6: ∧

Press input 1 key button then, the MATRIXPRO-II DVI 16x16 will recover the Default EDID to allocated input as below.

===EDID Configure=== EDID Copying….

EDID Reading….

3-2) If you select Auto Mix Mode, mixed EDID of all attached displays will be saved in allocated input.

3-3) If you select Output Copy Mode, MATRIXPRO-II DVI 16x16 reads EDID from any target displays and copies it in allocated input.

New EDID can be created or existing EDID can be modified using the Edit Data Mode. This feature is recommended for advanced users only.

▪Improper EDID setting can compromise the stability of the system

▪Not all computer graphics cards will be able to output a custom EDID resolution.

▪Be sure that you fully understand21this feature prior to use.

User’s Guide	Rev. 01
	For further information, please contact folsomsupport@barco.com