Barco 26-1302001-00 manual Input / output connection

Page 28

MatrixPRO-II DVI 16x16 Router

________________________________________________________________________

The left side of the control application shows the signal connection, resolution, EDID, and routing status of the inputs and outputs.

5.3.1Input / output connection

Click on one of the input channels and click on any of the output channels. If you click on input CH05 (Camera #1) and click on outputs CH05, CH06, CH07 and CH08, the input signal from CH05 will be connected to outputs 05, 06, 07 and 08 as shown in Fig 4-5.

To connect one input to all outputs, click All Link button and click desired input. Then all of the outputs will be connected to the selected input.

To disconnect all outputs, click the Link Clear button.

5.3.2Input channel status

Green LEDs above the input channel numbers indicate that a signal has been detected. In fig 4-5 above, CH05 and CH10 have detected signals.

When a signal has been detected, the resolution will also be displayed beneath the channel name (ex. CH05=1920x1080p).

If no signal is detected the input will display ‘Signal OFF’.

DEF., AUTO, OUT. and USER, indicate the current EDID mode assigned to that input channel (Refer to Chap. 4.2)

28

User’s Guide

Rev. 01

Image 28
Contents MatrixPRO-II DVI 16x16 Matrix Router User’s Guide Manual # RevisionUser’s Guide Rev Company Address Operators Safety Summary Terms in This Manual and Equipment Marking Cr6+ MatrixPRO-II DVI 16x16 Router Change History Table of Contents MatrixPRO-II DVI 16x16 Router Introduction Key FeaturesShipping Page Physical Description Front panel of MATRIXPRO-II DVI 16 XInstallation Initialization Edid ConfigurationEdid TCP/IP Control SetupLaunching Telnet RS-232 Launching HyperTerminal Unlink mode Front Panel Operation Link modeFunction mode Subnet Mask GatewayIP Address Edid Configure MAC AddressUDP Port Number Video GeneratorPage Hdcp Configure Hdcp ConfigureBaud Rate Reset ModeControl Lock Basic Setup PC Program OperationConnect Info Control Lock Mode Edid setupChannel Name NetworkOperation Input / output connection Output channel status Web control panel operation Commands Command input structureExamples of command inputs Link input and output Input and output statusMonitor output port setting Network settingEdid control command Hdcp Setting Baud rate setting for RS-232Control lock command Locking type and its Ascii dataFirmware update Power-On the MATRIXPRO-II DVI Page Page Hdcp notes Specifications Video InputsWarranty WarrantyContact Information Technical Support USA