SATO CL408-412e manual Function Description, DSW1 Function, Configuration

						Unit 4: Printer Configuration
				DSW1 FUNCTION DESCRIPTIONS
FUNCTION								DESCRIPTION
Data Bit			Sets the printer to receive either 7 or 8 bits of data for each byte transmitted.
Parity			Selects the type of parity used for error detection.
Stop Bit			Selects the number of stop bits to end each byte transmission.
Baud Rate			Select the data rate (bps) for the RS232 port.
Protocol			Selects the flow control and status reporting protocols.
					DSW2 DEFAULT SETTINGS
2-1		2-2	2-3			2-4		2-5	2-6	2-7	2-8
OFF		OFF	OFF				OFF	OFF	OFF	OFF	OFF
					DSW2 CONFIGURATION
DSW1		FUNCTION					SETTING		CONFIGURATION
2-1	Reserved						OFF
							ON
2-2	Media Sensor Selection						OFF	Gap Sensor
							ON	Eye-Mark Sensor
2-3	Head Check						OFF	Head Check Disabled
							ON	Head Check Enabled
2-4	Hex Dump						OFF	Hex Dump Disabled.
							ON	Hex Dump Enabled
2-5	Multi-Job Receive Buffer						OFF	Single Job Receive Buffer
							ON	Multi-Job Receive Buffer
2-6	Firmware Download						OFF	Disabled
							ON	Enabled
2-7	Protocol Code						OFF	Standard Protocol Mode
							ON	Non-Standard Protocol Mode
2-8	Operational Mode						OFF	Normal Operation
							ON	Emulation Mode for Original M8400
				DSW2 FUNCTION DESCRIPTIONS
FUNCTION								DESCRIPTION
Media Sensor Selection				Selects between a Gap or Eye-Mark detector.
Head Check				When enabled, will check for malfunctioning head elements.
Hex Dump				Allows hexadecimal printing of all data received to the print buffer.
Multi-Job Receive Buffer				Allows to continuously receive print jobs while compiling and printing other jobs.
Firmware Download				Places printer in mode for downloading software into flash ROM.
Protocol Code				Selects the command codes used for protocol control.
Operational Mode				Normal mode or for original M8400.

CL408-412e Supplemental Manual 4-4 PN: 9001159A