TRENDnet TEW-670APB manual Hardware Instalation, Front panel, Power, Status

Page 11

HARDWARE INSTALATION

Front panel

The figure below shows the LED Indicator of the Wireless LAN Access Point.

Power:

This indicator lights green when the Access Point is turned on.

Status:

This indicator blinkswhen the WLAN AP is working successfully. Otherwise, an on or off means the function of the WLAN AP has failed.

LAN:

This indicator lights green when the LAN port has successfully connected to an Ethernet network. Otherwise, the indicator blinks while transmitting and receiving data on the Ethernet network.

WLAN:

This indicator blinks during Wireless LAN activity.

4

Image 11

Contents Page Federal Communication Commission Interference Statement Regulatory Information/disclaimersEN 50385 FCC Radiation Exposure StatementEurope EU Declaration of Conformity EN60950-1EN 301 489-17 V1.2.1 EN 300 328 V1.7.1EN 301 489-1 V1.6.1 0560 Page Table of Content Overview of this User’s Guide About this GuideIntroduction FeaturesUnpacking Unpacking and SetupSetup Status PowerHardware Instalation Front panelAntenna Rear PanelHardware connections Side PanelCheck the installation Connect to the Switch/Hub/RouterLogin to the Wireless AP through LAN Configuring the Wireless LAN Access PointLogin to the Wireless AP through Wlan Wizard Main Screen of the Access PointSet your new password Secure your Wireless Network Page Good WEP Save and Restart StatusPage Basic Setting WEP Encryption WPA-PSK/WPA2-PSK Security WPA/WPA2-EAP SecurityRasius Server 1/2 IP Setting Access Point Mode Advanced Wireless SettingWireless Bridge mode Repeater mode Repeater mode configuration Click Apply SecurityTools Wi-Fi Protected Setup General Technical SpecificationsPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty