TRENDnet TEW-670APB manual EN 300 328 V1.7.1, EN 301 489-1 V1.6.1, EN 301 489-17 V1.2.1

Page 4

or the reference levels related to human exposure to radio frequency electromagnetic fields (110MHz - 40 GHz) - General public

EN 300 328 V1.7.1 (2006-10)

Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband transmission systems; Data transmission equipment operating in the 2,4 GHz ISM band and using wide band modulation techniques; Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive

EN 301 489-1 V1.6.1: (2005-09)

Electromagnetic compatibility and Radio Spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements

EN 301 489-17 V1.2.1 (2002-08)

Electromagnetic compatibility and Radio spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 17: Specific conditions for 2,4 GHz wideband transmission systems and 5 GHz high performance RLAN equipment

This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member states and EFTA countries, except in France and Italy where restrictive use applies.

In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain authorization to use the device for setting up outdoor radio links and/or for supplying public access to telecommunications and/or network services.

This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France.

Image 4
Contents Page Regulatory Information/disclaimers Federal Communication Commission Interference StatementFCC Radiation Exposure Statement Europe EU Declaration of ConformityEN60950-1 EN 50385EN 301 489-1 V1.6.1 EN 300 328 V1.7.1EN 301 489-17 V1.2.1 0560 Page Table of Content About this Guide Overview of this User’s GuideFeatures IntroductionSetup Unpacking and SetupUnpacking Power Hardware InstalationFront panel StatusRear Panel AntennaSide Panel Hardware connectionsConnect to the Switch/Hub/Router Check the installationLogin to the Wireless AP through Wlan Configuring the Wireless LAN Access PointLogin to the Wireless AP through LAN Set your new password Main Screen of the Access PointWizard Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption Rasius Server 1/2 WPA/WPA2-EAP SecurityWPA-PSK/WPA2-PSK Security IP Setting Advanced Wireless Setting Access Point ModeWireless Bridge mode Repeater mode Repeater mode configuration Security Click ApplyTools Wi-Fi Protected Setup Technical Specifications GeneralPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty