TRENDnet TEW-670APB manual Secure your Wireless Network

Page 17

Step2: Set the SSID, Channel, Operation Band, 802.11 mode and Channel Width

Please type the name of SSID and select the Channel, Operation Band, 802.11 mode and Channel Width. Then, click “Next” to continue.

Step 3: Secure your Wireless Network

The default security setting is set to NONE. There are four options: BEST (WPA2), BETTER (WPA), GOOD (WEP) and NONE. Please select the type of security and click “Next” to continue.

Image 17

Contents Page Federal Communication Commission Interference Statement Regulatory Information/disclaimersEurope EU Declaration of Conformity FCC Radiation Exposure StatementEN60950-1 EN 50385EN 301 489-17 V1.2.1 EN 300 328 V1.7.1EN 301 489-1 V1.6.1 0560 Page Table of Content Overview of this User’s Guide About this GuideIntroduction FeaturesUnpacking Unpacking and SetupSetup Hardware Instalation PowerFront panel StatusAntenna Rear PanelHardware connections Side PanelCheck the installation Connect to the Switch/Hub/RouterLogin to the Wireless AP through LAN Configuring the Wireless LAN Access PointLogin to the Wireless AP through Wlan Wizard Main Screen of the Access PointSet your new password Secure your Wireless Network Page Good WEP Save and Restart StatusPage Basic Setting WEP Encryption WPA-PSK/WPA2-PSK Security WPA/WPA2-EAP SecurityRasius Server 1/2 IP Setting Access Point Mode Advanced Wireless SettingWireless Bridge mode Repeater mode Repeater mode configuration Click Apply SecurityTools Wi-Fi Protected Setup General Technical SpecificationsPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty