TRENDnet TEW-670APB manual WPA/WPA2-EAP Security, Rasius Server 1/2, WPA-PSK/WPA2-PSK Security

Page 24

WPA/WPA2-EAP Security

If WPA or WPA2 EAP is selected, the above screen is shown. Please set the parameters of the RADIUS server.

Cipher Type: Select the cipher type for TKIP or AES encryption, Select Auto to auto detect the cipher type.

RASIUS Server 1/2:

1.Enter the IP address, Port used and Shared Secret by the Primary Radius Server.

2.Enter the IP address, Port used and Shared Secret by the Secondary Radius Server. (optional)

WPA-PSK/WPA2-PSK Security

If WPA or WPA2Auto PSK is selected the below screen will appear.

Cipher Type: Select the cipher type for TKIP or AES encryption, Select Auto to auto detect the cipher type.

Passphrase: The length should be at least 8 characters long.

16

Image 24
Contents Page Regulatory Information/disclaimers Federal Communication Commission Interference StatementFCC Radiation Exposure Statement Europe EU Declaration of ConformityEN60950-1 EN 50385EN 300 328 V1.7.1 EN 301 489-1 V1.6.1EN 301 489-17 V1.2.1 0560 Page Table of Content About this Guide Overview of this User’s GuideFeatures IntroductionUnpacking and Setup SetupUnpacking Power Hardware InstalationFront panel StatusRear Panel AntennaSide Panel Hardware connectionsConnect to the Switch/Hub/Router Check the installationConfiguring the Wireless LAN Access Point Login to the Wireless AP through WlanLogin to the Wireless AP through LAN Main Screen of the Access Point Set your new passwordWizard Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption WPA/WPA2-EAP Security Rasius Server 1/2WPA-PSK/WPA2-PSK Security IP Setting Advanced Wireless Setting Access Point ModeWireless Bridge mode Repeater mode Repeater mode configuration Security Click ApplyTools Wi-Fi Protected Setup Technical Specifications GeneralPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty