TRENDnet TEW-670APB manual Wi-Fi Protected Setup

Page 32

Restore Configuration Settings: Click on the “Browse” button to open a FileOpen Dialog box, where users can load previously saved settings and configurations. Upon selecting the saved file, click “Upload” and complete the restore process when the access point re-operates after it restarts.

Factory default settings: Click on “Restore” button to restore the access point back to its manufacture default settings.

Firmware Upgrade: Click on the “Browse” button to open a FileOpen Dialog box, where gets to select the firmware file, which download from the web for the latest version. Upon selecting the firmware file, click “Upload” and complete the firmware upgrade process when the Access Point re-operates after it restarts.

Wi-Fi Protected Setup

Wi-Fi Protected Setup: Enable or Disable the WPS (Wi-Fi Protected Setup) function

Status: Display the state (Un-configured State/Configured State) information of WPS.

Self-PIN Number: Displays the default PIN number of the Access Point.

Client PIN Number: Type the Client’s PIN number to negotiate with the Access Point via WPS protocol. It is only used when users want their station to join the WLAN’s network.

Push Button Configuration: Clicking the Start PBC button will invoke the Push Button Configuration (PBC) method of WPS. It is only used when the Access Point acts as a Registrar.

SNMP: Enable or Disable the SNMP function.

24

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Page Regulatory Information/disclaimers Federal Communication Commission Interference StatementFCC Radiation Exposure Statement Europe EU Declaration of ConformityEN60950-1 EN 50385EN 301 489-17 V1.2.1 EN 300 328 V1.7.1EN 301 489-1 V1.6.1 0560 Page Table of Content About this Guide Overview of this User’s GuideFeatures IntroductionUnpacking Unpacking and SetupSetup Power Hardware InstalationFront panel StatusRear Panel AntennaSide Panel Hardware connectionsConnect to the Switch/Hub/Router Check the installationLogin to the Wireless AP through LAN Configuring the Wireless LAN Access PointLogin to the Wireless AP through Wlan Wizard Main Screen of the Access PointSet your new password Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption WPA-PSK/WPA2-PSK Security WPA/WPA2-EAP SecurityRasius Server 1/2 IP Setting Advanced Wireless Setting Access Point ModeWireless Bridge mode Repeater mode Repeater mode configuration Security Click ApplyTools Wi-Fi Protected Setup Technical Specifications GeneralPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty
Top Page Image Contents