TRENDnet TEW-670APB manual Connect to the Switch/Hub/Router, Check the installation

Page 14

Connect to the Switch/Hub/Router

1.Plug in one end of the RJ45 network cable to a Switch/Hub port,

2.Plug in the other end of the RJ45 network cable to the Wireless Access Point.

Check the installation

The LEDs of the Access Point are clearly visible and the status of the network link can be seen instantly:

1.With the power source on, once the device is connected, the Power, LAN and WLAN port LEDs will light up indicating a normal status.

2.If the LAN Port’s Link indicator does not light up then check the RJ-45 cable if it is firmly connected to the RJ45 port, while the LAN is linked up to the Switch/Hub, the LAN port’s LED will light up.

7

Image 14

Contents Page Regulatory Information/disclaimers Federal Communication Commission Interference StatementEN60950-1 FCC Radiation Exposure StatementEurope EU Declaration of Conformity EN 50385EN 301 489-17 V1.2.1 EN 300 328 V1.7.1EN 301 489-1 V1.6.1 0560 Page Table of Content About this Guide Overview of this User’s GuideFeatures IntroductionUnpacking Unpacking and SetupSetup Front panel PowerHardware Instalation StatusRear Panel AntennaSide Panel Hardware connectionsConnect to the Switch/Hub/Router Check the installationLogin to the Wireless AP through LAN Configuring the Wireless LAN Access PointLogin to the Wireless AP through Wlan Wizard Main Screen of the Access PointSet your new password Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption WPA-PSK/WPA2-PSK Security WPA/WPA2-EAP SecurityRasius Server 1/2 IP Setting Advanced Wireless Setting Access Point ModeWireless Bridge mode Repeater mode Repeater mode configuration Security Click ApplyTools Wi-Fi Protected Setup Technical Specifications GeneralPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty