TRENDnet TEW-670APB manual Repeater mode

Page 28

Site Survey: This button allows user to enable the Site Survey function to scan for the available wireless networks and establish wireless communications with one. Select one of them listed to establish communications and click “Apply” button.

Remote AP MAC/SSID: Enter the MAC address and SSID of the opposite AP here.

Repeater mode

Configure the AP to Repeater mode; the AP will be a wireless LAN repeater that will extend the WLAN coverage range.

Note: The Wireless Bridge mode only supports using two more of the TEW- 670APB.

Repeater mode application

20

Image 28
Contents Page Regulatory Information/disclaimers Federal Communication Commission Interference StatementFCC Radiation Exposure Statement Europe EU Declaration of ConformityEN60950-1 EN 50385EN 301 489-1 V1.6.1 EN 300 328 V1.7.1EN 301 489-17 V1.2.1 0560 Page Table of Content About this Guide Overview of this User’s GuideFeatures IntroductionSetup Unpacking and SetupUnpacking Power Hardware InstalationFront panel StatusRear Panel AntennaSide Panel Hardware connectionsConnect to the Switch/Hub/Router Check the installationLogin to the Wireless AP through Wlan Configuring the Wireless LAN Access PointLogin to the Wireless AP through LAN Set your new password Main Screen of the Access PointWizard Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption Rasius Server 1/2 WPA/WPA2-EAP SecurityWPA-PSK/WPA2-PSK Security IP Setting Advanced Wireless Setting Access Point ModeWireless Bridge mode Repeater mode Repeater mode configuration Security Click ApplyTools Wi-Fi Protected Setup Technical Specifications GeneralPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty