TRENDnet TEW-670APB manual Status, Save and Restart

Page 20

Step 4: Save and Restart

The Setup wizard is now completed. The new settings will be take effect after the Access Point has restarted. Please click “Restart” to save the new configuration and reboot the Access Point. Click “Exit” to quit without making any changes. Users also can go back to modify the setting by clicking “Back”.

Status

This page shows the following information.

Firmware Version: Shows the current firmware version and released date code.

LAN: Shows the Mac address, IP address (default: 192.168.10.100), Subnet Mask and Gateway Address. The current LAN traffic calculated in terms of number of packets sent and received by the AP through a wired connection is also displayed.

12

Image 20
Contents Page Regulatory Information/disclaimers Federal Communication Commission Interference StatementFCC Radiation Exposure Statement Europe EU Declaration of ConformityEN60950-1 EN 50385EN 301 489-17 V1.2.1 EN 300 328 V1.7.1EN 301 489-1 V1.6.1 0560 Page Table of Content About this Guide Overview of this User’s GuideFeatures IntroductionUnpacking Unpacking and SetupSetup Power Hardware InstalationFront panel StatusRear Panel AntennaSide Panel Hardware connectionsConnect to the Switch/Hub/Router Check the installationLogin to the Wireless AP through LAN Configuring the Wireless LAN Access PointLogin to the Wireless AP through Wlan Wizard Main Screen of the Access PointSet your new password Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption WPA-PSK/WPA2-PSK Security WPA/WPA2-EAP SecurityRasius Server 1/2 IP Setting Advanced Wireless Setting Access Point ModeWireless Bridge mode Repeater mode Repeater mode configuration Security Click ApplyTools Wi-Fi Protected Setup Technical Specifications GeneralPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty