TRENDnet TEW-670APB manual Rear Panel, Antenna

Page 12

Rear Panel

The figure below shows the rear panel of the Access Point

Rear Panel

LAN

Ethernet port with 10/100Mbps Fast Ethernet connections, connect this port to a switch/hub.

RESET

Press the “RESET” button for more than 5 seconds buttonto reset the settings back to factory default.

Power

Connect the DC Power Adapter plug to the AP’s power jack.

Antenna

Two external 3 dBi dipole antennas.

5

Image 12
Contents Page Regulatory Information/disclaimers Federal Communication Commission Interference StatementFCC Radiation Exposure Statement Europe EU Declaration of ConformityEN60950-1 EN 50385EN 300 328 V1.7.1 EN 301 489-1 V1.6.1EN 301 489-17 V1.2.1 0560 Page Table of Content About this Guide Overview of this User’s GuideFeatures IntroductionUnpacking and Setup SetupUnpacking Power Hardware InstalationFront panel StatusRear Panel AntennaSide Panel Hardware connectionsConnect to the Switch/Hub/Router Check the installationConfiguring the Wireless LAN Access Point Login to the Wireless AP through WlanLogin to the Wireless AP through LAN Main Screen of the Access Point Set your new passwordWizard Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption WPA/WPA2-EAP Security Rasius Server 1/2WPA-PSK/WPA2-PSK Security IP Setting Advanced Wireless Setting Access Point ModeWireless Bridge mode Repeater mode Repeater mode configuration Security Click ApplyTools Wi-Fi Protected Setup Technical Specifications GeneralPhysical and Environmental Network Glossary Page Page Page Page Page Limited Warranty