12.Attach any cables that are required by the GbE switch module, see Chapter 4, “Cabling,” on page 21. For the locations of the connectors on the BladeCenter unit, see the documents that came with the BladeCenter unit.
13.Replace the
Removing the GbE switch module
To remove the GbE switch module, complete the following steps:
1.Read the safety information beginning on page v and “Installation guidelines” on page 9.
2.Remove the
3.Disconnect any cables from the GbE switch module that you are removing.
4.Pull the release latch toward the bottom of the GbE switch module as shown in the following illustration. The module moves out of the bay approximately 0.64 cm (0.25 inch).
RS232
LINK
1 TX/RX LINK
2 TX/RX LINK
3 TX/RX LINK
4 TX/RX
I/O module
Release latch
5.Slide the GbE switch module out of the bay and set it aside.
6.Place either another GbE switch module or a filler module in the bay within 1 minute.
7.If you placed another GbE switch module in the bay, reconnect any cables that you disconnected. For more information about cabling the 10GbE switch module, see Chapter 4, “Cabling,” on page 21.