IBM Nortel 10 manual Disconnecting the XFP module cable, Connecting the SFP module cable

Disconnecting the XFP module cable

To disconnect an XFP module cable, complete the following steps:

1.Squeeze the release tabs and gently pull the fiber-optic cable from the XFP module.

2.Replace the protective caps on the ends of the fiber-optic cable.

Connecting the SFP module cable

To connect the SFP module cable, slide an RJ-45 cable into the SFP module connector until it clicks.

TX/RX LINK

4 TX/RX

3

Disconnecting an SFP module cable

To remove an RJ-45 cable from an SFP module, gently grasp the tab on the connector of the cable and pull the cable out of the SFP module.

24Nortel 10 Gigabit Uplink Ethernet Switch Module: Installation Guide