IBM Printing System Receive dump mode, Printer reset, Resource protect mode, Auto Continue ON/OFF

1. Printer Settings (15 ppm copier)

Menu	Item	Available settings	Remarks
number
P71	Receive dump mode	(1) OK
	The data that the printer receives for debugging
	programs and files is turned into hexadecimal code
	and printed out. If “OK” (setting: 1) is selected here,
	this receive dump mode will be activated. The
	receive dump mode will be canceled under the
	following circumstances:
	• The Start key is pressed in the printer mode.
	• A force-print time-out occurs.
P72	Printer reset	(1) OK
	Resets the Printer Board only even without turning
	the power to the machine OFF.
P73	Resource protect mode	(1) Off	At least 16 MB of additional memory
	Protects the resource data of fonts and macros	(2) Permanent	(option) must be installed.
	downloaded through PCL6 and, even if the emula-	(3) Permanent/Temporary
	tion protocol is switched, the PCL resource will be
	saved in the printer’s memory. If “Permanent”
	(setting: 2) is selected here, temporary resources
	will not be saved. If, however, “Permanent/Tempo-
	rary” (setting: 3) is selected, temporary resources
	will also be saved.
	Permanent/Temporary
P74	Auto Continue ON/OFF	(1) On
	If one of the following error messages appears and	(2) Off
	“On” has been selected here, the error state will be
	released and the printing operation will be restarted
	automatically after a specified amount of time.
	“Memory overflow (error code : E70)”
	“Print overrun (error code : E80)”
P75	Recovery time for Auto Continue	000 - 495 (sec.)
	Sets the amount of time before Auto Continue
	engages when “On” (setting: 1) is selected under the
	“Auto Continue ON/OFF” setting (menu: P74). If
	“000” seconds is selected here, Auto Continue will
	engage immediately after the error.
P76	Service Rep Status Page print out	– – –	Print out will begin as soon as the
	Prints out a Status Page for use by your service		corresponding menu number is
	representative.		displayed and the Enter key pressed.

1-6